
Fury 148mm Proximity Racer
thingiverse
"I'll wrap him in a bear hug, I'll stroke his furry coat, I'll squeeze the life out of him and I'll scream at the top of my lungs 'That's My Fury'"\nTake a look at this snazzy little X-style racer quad. Not too showy but equipped with the right gear, featuring 22xx size motors, specifically designed for 16x19mm bolt patterns with 3mm bolts. Therefore, it won't accommodate 1806 or 1306 motors with 2mm bolts unless you use adapters. Any of the 20amp mini ESCs will fit, from Zeus to Little Bees and classic DYS units, all standard CC3D or Naze flight controllers work, so tune it up and then add a protective skirt. No holes needed... I recommend a 25mw video transmitter here since there's little cooling inside. Additionally, advanced soldering skills are required to attach a pigtail to the vtx for easier assembly. The camera pod is designed specifically for the Aomway 700tvl CMOS camera from Hobby King, but most CMOS cameras should fit just fine. It takes standard antenna tubes if you're using a full-range RX with it. The battery tray was built around a 1500mah 3s pack from Lumenier, featuring a 35x25x89mm compartment size when using flush screws under the main plate like I did. This one's definitely for advanced builders only..."\nGood Luck...\nBrian
With this file you will be able to print Fury 148mm Proximity Racer with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Fury 148mm Proximity Racer.