Furrion S7 Display Shroud

prusaprinters

<p>The display for the Furrion S7 is not as bright as it should be for where it needs to be mounted to be used while driving. &nbsp;This shroud blocks the sun to help it to be viewed easier. &nbsp;Be sure to print with the shroud part pointing up to minimize print time, essentially put it on its back. &nbsp;I REALLY tried to design this without the need for supports but I couldn't do it. &nbsp;Print in PETG or some other sort of heat tolerant material. &nbsp;0.20 is adequate, add a brim as there isn't a lot of surface area touching the build plate and could detach easily. &nbsp;Supports everywhere but allow for automatic detection (0 value) if using prusaslicer. &nbsp;Only the bottom part (the part that fits over the monitor itself) needs supports.</p>