Furitek Lizard Pro w/ Bluetooth ESC Box SCX24

cults3d

I quickly designed this case for the Furitek Lizard Pro ESC w/ Bluetooth because i was sick of seeing it hanging loose under the body of my scx24. I left a big enough space on both sides so you can turn the ESC on and off easily, wires dont pinch and you can connect and disconnect the motor without taking the cover off the box. Also the overhang on the cover does not allow the bluetooth module to fall out of the box. I used (1) m1.4 x 5mm screw to hold the cover on. I made the hole 8mm deep in case you want to use a longer m1.4 screw. If you dont know what a m1.4 screw is or dont have a way of measuring the length... it is the same screw used to hold the bumpers on to the frame of an scx24. The screw hole on the cover of the box is countersunk for the head of a m1.4 screw. 1 screw is plenty to hold the cover on without worrying about it coming loose or falling off. I recommend printing the cover of the box on its side, it may take 10 minutes longer than it would to print it flat but you will get a much smoother countersunk hole. Print the box itself flat on the build plate. May take a little force to get the screw started but i wanted it to be a snug fit. The box is solid and will break or snap under normal conditions. I did a snap test and it took quite a bit of force before it broke. You wont be experiencing that type of force on the box when it is in place under the body or wherever you decide to mount it. I printed this at 15% infill but you can print at 20% if youd like. No supports, no build plate adhesion needed.