Fully parametric plant support

prusaprinters

Support for plants around a circular base. Fully parametric (see the attached scad file), to print any size. Print upside down, no support needed whatsoever.Scad file parameters:ParameterDescriptionDefault valueUnitinner_diameterDiameter between the feet - if your plant has some sort of circular base you want to put this support around of, this is the value you're after. This is also what defines the main diameter.56mmhole_diameterDiameter of the hole for the plant. Be mindful that depending on the angles below, the opening will most likely be smaller than that.5mmring_widthWidth of the outer ring.11mmsupportsNumber of supports. Less supports will mean a larger opening to the centre hole, as the angle of the opening is the angle between two supports.5n/asupport_angleAngle each support occupies. Larger angle means larger supports.15Degreessupport_heightHeight of the supports30mm