Fully Customisable replacement watch strap keeper

thingiverse

Disclaimer: All watches are unique.Be sure to check your watch's dimensions carefully.A Replacement Watch Strap Keeper for Cheap Watches.I designed this solution after my own inexpensive watches broke in the same way.You will need to print it with a flexible filament of any kind, but it doesn't have to be super flexible like Ninja Flex.It just needs to stretch a little bit.The measurements should be taken according to your watch's size and your printer's tolerance.Use a vernier caliper to measure accurately unless you want to approximate it.Ensure the wall thickness is higher than the original strap because layer adhesion will vary depending on the material.Print text side down if you decide to print with text.Depending on your printer and build surface, use a raft and/or supports for better results.This should not be too demanding for most printers, except for flexible filament requirements.Leave suggestions in the comments, I'll improve it when I have time.Thanks to user WrinklyWink for informing me of the proper name.Tested Settings for Semiflexible Materials:TS = 7.lt = 1.7.w = 10.5.b = 9.7.l = 26.2.bt = 1.45.Highly recommended because it lasts much longer than default settings.