Fully 3D Printed RC Plane

thingiverse

Hey everyone, This is a custom R/C Plane designed entirely in Fusion 360. Unfortunately, I haven't had the chance to print out all of the parts yet, so if you end up printing and flying it, please be sure to share your results. Recommended Equipment: Hitec Feather Servos A minimum 2000-2500 kv miniquad motor paired with a 5-6 inch propeller A matching ESC and 3s LiPo pack - anything more powerful will likely result in too much speed A reliable Tx/Rx Pair capable of Elevon mixing, at the very least three channels are required Good quality Control Horns - I'll design some for you soon Note: Due to its design, this plane isn't recommended as a beginner's model - it doesn't appear to be lightweight or slow. CG should be approximately 140mm from the front of the plane. Happy Flying!