Full One Handed Xbox One Clip-on Attachments (Right Hand)

prusaprinters

<p>The print comes in many parts that will need to be clipped together.&nbsp;</p><p>When clipping on the main base hook the arm on the left side than push the part up until fully clipped and the underneath is mostly flush.&nbsp;</p><p>For the LT and LB buttons the part will slide under the bar and then twisted to pop into the bar than the parts can be slid to place.&nbsp;</p><p>The D-pad buttons clip on and go in order from top to bottom(up, right, left, down)</p><p>The part that goes on the joystick gets slid on from the back and than the short are clips to the leg that goes down to a table.&nbsp;</p><p>The leg that goes down pushes against a table or chair (preferably padded for more grip) than all you have to do is push the controller around to move the left stick.&nbsp;</p><p>Print settings - (Ender 3)</p><p>Material - pla</p><p>Supports - yes</p><p>Layer height - 0.2 mm</p><p>Infill - 20%</p><p>&nbsp;</p><p>&nbsp;</p>