Fulament E3D Hermes Sidewinder X1 Mount

thingiverse

This newly designed mount eliminates all the issues associated with the original Sidewinder mount provided by E3D. The improved features include: •A more compact design, printing in two parts instead of three •The PCB is positioned closer to the extruder, reducing strain on the already short wires •The ribbon cable is slightly elevated above the E3D included mount **What You'll Need:** •The screws from the stock extruder that come with the Sidewinder •Screws included with the Hemera •x2 M3 x 8mm screws **Different Versions:** V.1- BL Touch and no nozzle offset required V.2- Without BL Touch, no offset needed V.3- Without BL Touch or supports on print, but requires offset adjustment in firmware for the nozzle **BL Touch XY Offsets:** •X: -3 •Y: +27 **Buy the E3D Hemera:** https://fulament.com/collections/e-3d/products/e3d-hemera **Install Guide:** https://fulament.com/blogs/technical-review/installing-fulament-s-hemera-mount-on-the-sidewinder-x1 **Buy the Mount Pre-Printed:** https://fulament.com/products/pre-printed-e3d-fulament-hemera-mounts-abs **Nighthawk V2-** Original Thingiverse: https://www.thingiverse.com/thing:4081582 This version features lower nozzles and is centered in the middle, which should offer better flow. A 200mm bridge test was done by my friend, and there was only a slight sag; I've attached a picture. **Printing Tips:** Print in PETG or ABS. If you think you can remove them, do supports as pictured, or print without supports. The inside will sag a little, so turn up your part cooling. Orient as pictured. Layer height as detailed as you want, and infill at least 10%. **Hardware Requirements:** Mounting the fan to the mount requires (3) M3x25 bolts and (3) M3 Nuts. Mounting the plate to Hemera requires (3) M3x5. You will need to extend your stock fan wire to use the cooler. For the cover, you'll need (2) M3x12. **Hardware:** Duct to Mount: (3) M3 x 25, (3) M3 Hex Nut Mount to Hemera: (3) M3 x 5 Cover to PCB: (2) M3x12, (2) M3 Hex Nut **Donate to the Original Designer Chanh Phuong:** paypal.me/3dchanh