fuel cell box

thingiverse

I took the basic box and remixed it with another project box my friend was designing but couldn't get to fit correctly. I'm still new to CAD, so this entire thing was done in Meshmixer with added parts from my friend's build along with a wall piece to act as a wire baffle on the side from another box. Hopefully everyone likes this and finds it helpful. Edit: After the first print of the top cell failed due to too much retraction, I reduced my retraction by 0.5mm. After the second print, it was a success, but the small bolts around the gas cap were too small and didn't stick well because of so many retractions. Same with the smaller hose nozzles on the sides of the cap - they were weakened as well. I'm going to adjust the sizes of those parts later unless someone else updates them before me. The print will need filing. Print Settings: Printer: Kossel 2020 by FOLGERTech Rafts: No Supports: Yes Resolution: .2 Infill: 20% Notes: Again, nothing is perfect about this - I just saw the basic box and ran with what I knew... enjoy One last note: You'll need to scale it up a bit. I haven't gotten my scaling right yet; I went for 2.5 scale up.