FTC SkyStone 200mm Printer

thingiverse

Since I have a Wanhao Duplicator 6 with a 200mm cubed volume, which meant I couldn't print the block directly because the 8 inch dimension is just over 208mm. So I tossed the model into Tinkercad and cut up the files. The trimmed will fit on the print bed and let you print with only one dimension cut. I put warning text on the top that should print in easily. The other two are a half and half with an orientation point in them to let you glue it back together. I will be printing the AB halves next after the trimmed block so they are untested. The Triangle should fit directly together but if need be, I can shrink that down a bit in case the fit is too tight. I am printing in PLA with Cura's TriCubic infil at low percentages. Not sure how the top will turn out.