FT TINY TRAINER ESSENTIALS

thingiverse

12-9-18; I noticed this morning that the firewall is separating from the side wall of the power pod due to layer separation. This calls for a solution: lay the power pod tray bottom on the build plate instead of the firewall being on the build plate. The wheels used are linked below. Three millimeter by sixteen millimeter machine screws were used for the axles. A one-eighth inch drill bit was employed to ream out the axle holes in the wheels, while a seven sixty-fourth inch drill bit was utilized to ream out the hubs on the landing gear so that the three millimeter screw would thread into the plastic and be tight. https://amazon.com/Du-Bro-145MS-Micro-Sport-2-Pack/dp/B000PE69MY/ref=sr_1_2?ie=UTF8&qid=1544027619&sr=8-2&keywords=du-bro+1.45 A warning is in order: I had to add approximately twenty-nine grams of weight to the tail to achieve the correct center of gravity with an eight fifty mah battery after adding all this stuff, but the plane still flies well with a two thousand twenty four motor.