
FT Guardian Gremlin v2 Angled Receiver Mount
thingiverse
I have a FliteTest Gremlin V2 and experienced that things were a little tight in the recommended location of the receiver. I wanted to make as simple, angled piece that mounted using the hex nut/spacer on the outer side of the designated space. This will slip in perfectly in-between the two mount points of the FPV camera mount and I found it easiest to pre-align them, slip the hex spacer through, then screw them all down together. https://store.flitetest.com/ft-guardian-gremlin-v-2/ This was printed with PETG, although I imagine about any rigid material would work. At 15% infill, this came in at just over 2g. More holes in the ramp or a reduction in the connection points to the hex spacer slot would reduce this, but I found holes in the ramp didn't print well on my Ender and I a little extra weight was worth some impact resistance for the connection points. EDIT: I added two more revisions. I'm still rolling with the original design, but realized there was a fairly easy way to cut mass at the loss of some rigidity: Minimal v1: this one will definitely need support to print, but comes in at ~0.9g Minimal v2: much less protection, but no need for supports either. This one comes in at ~0.8g. I also found my initial design to be still cutting it close for space. This one definitely adds a bit more room for the board.
With this file you will be able to print FT Guardian Gremlin v2 Angled Receiver Mount with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on FT Guardian Gremlin v2 Angled Receiver Mount.