FT A-10

FT A-10

thingiverse

Here is the rewritten text: My printing settings are listed below: Canopy: I used 1 point front and back, printed as a plug in Spiralize mode at .4mm thickness. After it's done, fill it with plaster of pairs and glue the two halves together. Next, grab a large pop bottle and heat shrink the bottle over the plug. Cockpit and Ejection Seat: I had to scale this up to 1.1 times normal size to print correctly, as the default size was too small. Print upright at .4mm thickness with 15% infill and supports everywhere - it might need some cleaning but will be worth it. EDF Pods (Front, Back, Middle): Print in Spiralize mode at .4mm thickness. Simple! EDF Pod Inner: After designing it, I found that I needed to scale down the size by re-scaling it to .996 of its original size before printing - it slides right in perfectly. EDF Fan Holder: Flip 180 degrees and print on its face with the 4 feet upright. Print at 15% infill. Tail Exhaust: Make sure top fill, bottom fill is on and set to 1mm base thickness. Then print in Spiralize mode at .4mm thickness. EDF 28 Blade Fan: Print at 15% infill, flip it over and print flat at .4mm thickness with normal print settings. Pilot: To fit the pilot inside the cockpit, I had to scale it down to .412. If you want a slightly smaller one, I printed it at .378 size, but the scaled-down size would be .412. Print with supports everywhere - I only use 15% supports on all my prints.

Download Model from thingiverse

With this file you will be able to print FT A-10 with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on FT A-10.