FS-X: Fixed Stock for the NSK-X

prusaprinters

This is the official fixed stock for the NSK-X Foam Dart Blaster. It is the same length-of-pull as the collapsible stock and only necessitates the replacement of 3 parts on the blaster. It has an integral battery compartment that is slightly larger than the forward battery tray; theoretically, with some wiring, you could run the blaster off 2 batteries in parallel for a significantly higher max amp draw, but that isn't necessary in the majority of flywheel and motor setups. In testing, it is a sturdy piece that won't easily break and has a more comfortable cheek-weld and stock pad compared to the collapsible stock.The battery tray fits the same suggested 850mAh battery as normal, but with more space for wiring and a LiPo alarm. To get to this battery compartment, all you would need to do is undo the top thumbscrew and pull the stock back as if you were extending the collapsible stock. If utilizing the stock's battery compartment, it is necessary to have slightly different wiring, as the battery connection is now at the rear instead of the front.Assembly is similar to the rear trunnion, stock pad, and recoil pad of the normal collapsible stock. The majority of this hardware is the same as the parts the fixed stock replaces. You will require:6x 6x3mm magnets1x M3x4mm heat set insert4x M4x6mm heat set inserts4x M4x12mm SHCS (Socket Head Cap Screw)Install the magnets using glue, melt in the inserts, screw the stock pad to P1, and slide/glue P2 onto P1. To install on the blaster, remove the rear trunnion from the back of the blaster and unscrew the stock pad and recoil pad from the aluminum bars. Slide the fixed stock assembly onto the bars in place of the stock pad and install the SHCS. Replace the top thumbscrew to prevent inadvertent opening of the blaster.Print InstructionsBecause of the structural nature of the parts, I suggest using 5 or more walls and 25% or higher infill. No supports are necessary; place the rear of P1, the flat side of P2, and the flat side of the stock pad on the build plate. P2 exists to match the color of the rest of the upper receiver on your blaster. Other NSK-X Files and Accessories:Core NSK-X BlasterLDSMM-X: Leedle Dynamics' Stringer Mega Masterkey for the NSK-XFS-X: Fixed Stock for the NSK-X (Currently viewing)FFDCA-X: Front Fan Duct Cooldown Attachment for the NSK-X NONE of my files are to be used or sold by Frontline Foam, by downloading my files, you agree that you are not Frontline Foam and/or related to Frontline Foam or Derrikk Sun.