FS Scaleo Face Cover Hooks

thingiverse

<b>INFO:</b> Even though it seems like the hooks for the top part of the front face are longer in the final print, they're not as long as you might think. I fixed those hooks a few days ago and tested them - now everything fits perfectly! <hr> <b>Got one or more broken hooks on your Scaleo 400/600/600i front case face? No problem!</b> I recently brought out my old Scaleo 600 to reuse it with a brand-new motherboard, and I remembered breaking some of the hooks on the front face back in the day (when I was thoroughly cleaning the case). I designed replacement hooks so that you just need to print them, put glue inside the tube, and stick it onto the broken part (after sanding down any remaining bits from the pole and removing tiny leftovers from the broken-off hooks). Then, place it over the old tube. To make up for the tube holding the new hooks, I trimmed ~2mm (~0.08 inch) off the barbs. It should fit perfectly for both big and small cases. As for the top hooks, I simply created a rectangle with one open side (to match the slope of the case itself) and placed the barbs/hooks on top of it - again 2mm (0.08 inch) shorter to account for the parts body itself. The top hooks need to be bent inwards a bit (I recommend using heat to carefully bend them inwards without breaking the hooks off the base, <b>BE VERY CAREFUL WHEN USING ANY OPEN FLAME!</b>) to match the original shape of the case's hooks.