FrSky X-LITE Stick Caps / Extenders

thingiverse

The original sticks are just too small and they don't provide a decent thumb contact area, so I came up with these simple caps to fix the problem. If the caps don't fit snugly on your sticks (and this might depend slightly on what type of filament you're using), try scaling them down a bit - 1% should do the trick. Here are my recommended print settings: - Layer height: 0.2mm - Use supports, but only for the build plate and space them out at 5mm - Infill percentage: 8% - Print a raft to ensure good adhesion