Frozen - Anna bust

thingiverse

This remixed version of Anna can be printed without discomfort; however, printing it is challenging, yet achievable. UPDATE: The larger version, scaled to 190%, requires a significant amount of filament - I've reached approximately 36% completion and used around 65 meters of filament so far; please keep an eye on your roll. UPDATE II: If the initial layer does not print correctly, try moving the model down by 0.5 millimeters under the bed; this may help ensure proper first-layer printing. UPDATE III: If you plan to print a larger version, verify that you have sufficient filament available; my final result weighed 400 grams with supports and approximately 300 grams without them; I ran out of filament during printing. Print Settings: Printer: Prusa i3 MK2 Rafts: No Supports: Yes Resolution: 0.15 millimeters Infill: 30% Notes: You can safely omit the bottom layer (it's recommended as the model has some bugs); I used four shells (three are sufficient). I scaled the model to 190% of its original size, resulting in a height of almost 20 centimeters; I set infill to honeycomb. UPDATE: I'm unsure if 30% infill at 190% scale is sufficient; perhaps 20-25% would be enough.