Frosthaven Player Dashboard

thingiverse

I have not printed this yet, but remixed based off some requests I saw to allow for sleeves. I measured all sleeved sizes and made adjustments. This did change the overall design in 2 meaningful ways: In order to keep the same rough layout, I had to increase height. This is the oversized version @ 210 mm tall.V2: Made slightly wider so thumbholes were actually usable. Also recessed the holes a little more than where the cards sit to make it easier to grab the edges of the bottom cards. in order to print on a bed <200 mm, I made a version that had to lose a card slot in order to rotate and adjust for sleeved cards. this one sits at 190m tall.I also have one for even smaller printers, sitting at 180 mm tall. I still have some work to do on this one. Note this does not account for all player cards to be sleeved. This is assuming just the active hand, modifier, and item cards are sleeved. It would have to be much deeper to allow for everything. These are all made with 5x5 magnets in mind, per the original design. I made the holes .15 mm larger to accommodate. shout out to Darkw3ight for the original design.