Frosthaven Boss Proxy: Vestige of the Imprisoned God

thingiverse

Here's my proxy model for the Vestige of the Imprisoned God. This is one of the rare 3-hex monsters in Frosthaven, which was very helpful for me because the artwork is that giant limb, towering above the trees… which was really hard to fit onto a hex! I initially tried matching the pose from the artwork, but to get any sense of scale on it, it had to be so tall that it seemed like storage was going to be problematic.So, I flipped ahead in the scenario book and was relieved to find that this guy actually occupies 3 hexes. That allowed me to tweak the pose a bit (so that it's more like it's pulling itself up out of the ground), which let me make it big enough to create that sense of scale without making it an actual giant that would be too painful to store when not in use.The model needs minimal support; a few of the trees along the edge will have small islands where their branches are pointing downwards. I put a few support points on the limb as well, just because it's got a lot of material to build off of a relatively small contact area and I didn't want it to start wiggling during the print.As always, the .blend file and pre-supported .3mf (including the one that I used to print this on my Prusa MK3, although the support points should work for SLA printers) for this model are available to my patrons at https://patreon.com/VirtuallyJason. If you appreciate my work and have a few dollars to spare each month, please consider joining!