Frosthaven Algox Boss Proxy

thingiverse

Hey everyone - here's my model for the Frosthaven Algox boss! I'll avoid saying too much about the model in order to avoid any potential spoilers, but I just want to give some quick printing advice: make sure that there's some support under the lower part of the staff. I clipped it into the foot to give it better bed adhesion, but the end of the staff is still pretty small and it builds up at a pretty steep angle. Other than that, the support requirements are pretty much what you'd expect! As always, the .blend file and pre-supported .3mf (including one that I used to print this on my Prusa MK3 (if applicable), although the support points should work for SLA printers) for my models are available to my patrons at https://patreon.com/VirtuallyJason. If you appreciate my work and have a few dollars to spare each month, please consider joining!