Frontierfila 1KG Spoolholder

thingiverse

I made a simple little holder for my Frontierfila 1KG spools using Fusion360. To make it work, I needed 22x8x7 bearings that fit snugly with just a tap of the hammer. The holder also "clicks" into place on the spool, which is precisely 58mm in diameter. This setup allows me to hang multiple spools close together on an 8mm rod and they roll smoothly! I printed it with two top and bottom layers, two walls, and about 40% grid infill. To get it right, I had to print the "bottom" upside down and then rotate it 90 degrees. I also added supports for the smaller hole - you can see that in the picture.