Front XT60 mount for Armattan Rooster

thingiverse

There's a lip on both top and bottom that prevents the XT60 from moving when plugging in or out of the lipo. You may need to use a shoehorn with something thin to ensure the lip is properly seated. It's much harder to remove it, but a shoehorn helps too. Print this model using TPU with supports. You can find the Fusion 360 source file at: https://a360.co/2LdWZch An alternate version was created to make it easier to plug in and out of the XT60 while the battery is strapped on. This version is called rooster_xt60_front_mount_angled.stl. The Fusion 360 source for this version can be found at: https://a360.co/2IHBuTF This model has two parameters that you can adjust. The angle, currently set to 29 degrees, and the length above the bottom mounting strip, currently set to 12mm. If you change the length above, it will automatically adjust the length below to ensure the entire length remains the same, fitting the XT60 perfectly at 16mm.