Front Side Cable Chain Mounts for Hydra Fan and Hotend Mount for Creality Ender X Gantry

cults3d

Connect your Hydra hotend cables to your Ender 3 X drive box with this chain setup. You'll need slightly longer M3 bolts, approximately 25mm to use the overlay version that just mounts over the existing box. * This design includes clips to allow you to re-close your chains without having to feed wires through it. They are friction fit. I considered using Voron zip chains for the same concept but I like these better so far, no waste when you need to reopen it. I'm using a smaller creality z-axis motor to drive my extruder, you may need to clip off the guide tab if yours is much bigger. I'm including another (untested) version that includes the whole box (minus the endstop mount) for those who want to reuse their stock screws. Apparently it can be hot-glued to the right spot, though I would hesitate to do so personally.