Front Service Manta E3EZ mount on Meanwell

thingiverse

This is designed specifically for the Manta E3EZ with the TFT35 SPI and CB1. However, the footprint should fit most Creality boards and drop-ins. This was designed to mount on the back of the meanwell PSU. Furthermore, the clips are designed for the whole setup to clip onto the 2020 extrusion. I ended up using a clamp to force it into place. I had to take it off once, and had to pry it off. Once it is on there, it is on there. The front lid was designed to accept magnets. Mine has enough friction where magnets are basically useless. Magnet size was designed for 3mmx2mm cylinder. This was designed for easy access to the main board. The box and lid were both designed to be printed face down on an Ender 5 Plus