Fritz Fon C5 Belt Clip Two Parts

thingiverse

Hey fellow Makers! All existing belt clips for the Fritz Fon C5 on Thingiverse are one-piece designs that aren't fully suitable for FDM printers. When you print along with the clip, it's stable, but not the cover and vice versa. The clip of these models tends to break along the layer line, so I came up with a two-piece clip design. Depending on how accurate your printer is, you'll still need to sand a bit with fine sandpaper until it fits and smoothes out any sharp edges that might be present. One drop of superglue makes it stable as a one-off piece. The shell could potentially be fixed in place with a strip of double-sided tape attached to the phone for a firmer fit. Enjoy! If you have an improvement proposal, please leave a comment below. Note: Use at your own risk - no liability is assumed for damage to your device!