Frigidaire Fridge Water Paddle/Dispenser/Lever

thingiverse

This is the plastic part liable to break from the several hundred dollar module for the entire front replacement on the fridge. I refused to pay when all that was needed was a replacement plastic part. I found the original of this which had the correct lever/trigger design for a different fridge. So, I remixed to try to match the original look of my fridge. I printed this with black PLA at 100% infill at -75 degrees (see photo). It's not a perfect replacement for that module's part, but it fits great and reasonably resembles the original part. No issues with its use. It's seemed relatively sturdy at as low as 5% infill if that's a concern.