Fridge / Refrigerator Shelf for Frigidaire (Single Print, 400mm Bed Required) Several Sizes Available

thingiverse

Thanks to @Kemmotar for the excellent design of the original model. I created various sizes and decided to put my Ender Extender kit to work. The result is truly impressive. 30% Infill was used here in a Cubic Subdivision arrangement. Only two bottom layers and two top layers were printed, along with a single wall width. Keep in mind that you'll need to double those numbers if you're using a normal 0.4mm nozzle; I was using a 0.8mm nozzle, so a "single wall" for me is 0.8mm, not 0.4mm. The print was done in 0.4mm height with dynamic heights enabled in Cura (variance allowed: 0.8, step size: 0.4). Supports were required, but I set my overhang to 50 degrees and my supports to "gyroid" to safely make it to the desired height. It's a great print that meets expectations. My original print was in solid orange, but unfortunately, my cable feeding my extruder failed at 80%. However, it works well now. Note: there is some wiggle room on the left and right, which isn't enough to be concerned about. One might size up the X-axis by 1% or 2% according to your fridge's exact dimensions. I chose not to adjust it because every nook and cranny inside a fridge is rounded, making it hard to know if it'll fit perfectly or need additional sanding.