Fridge Post-it/Marker Holder

thingiverse

I'm fed up with staring at a Post-It pad and marker stuck out of an envelope taped to my workplace fridge, begging for us to label our stuff inside. I've only ever created one simple extruded sketch before, so I figured it was time to push myself and tackle a small project to learn more. The cutouts are designed specifically for neodymium magnets from Michael's - they're what I had lying around at the time. Edit 2: I made some changes to the initial design you see here printed out. The cutout in front wasn't low enough, so I went back and adjusted it to give me more room to grip while pulling up. Edit 3: Mk3 is the refined version after using Mk2 for a bit - it also has a much shorter print time. This one's the recommended version; check out the pic of it in action on the fridge! I've put in around 10 hours total with FreeCad, including about three hours working on this particular project. I've been doing smaller projects to get used to using the software, so I'm still pretty green when it comes to modeling - if you take a peek at the FreeCad doc, it's not just about downloading the STL.