Frenzy Brick "Prusa Lover"

thingiverse

This Brick is for All Prusa Lovers... But Especially for Tom Jackson and His Amazing Brick Wall. You Can Choose Between Two Versions of This Brick: - Prusa Lover with Daffodil (V01) - Prusa Lover with Spinning Sun (V02) _____________________________________________________________________ Instructions: Prusa Lover Daffodil Print Each One of These Files Without Supports: - Brick_V01 - Calyx_V01 - Petal_01_V01 - Petal_02_V01 The Brick is Printable in Two Colors by Swapping Filaments at Layer Height 14.2 (If Printed with 0.2 Layer Height). If You Don't Know How to Set Filament Swaps, Watch My Tutorials: https://youtu.be/i9IEojl87tI https://youtu.be/RZgDdki_ZHk The Calyx is a Solid Body and Should be Printed in Vase Mode. Alternatively, Print it Without Infill and Top Layers. Print Both Petal Files. Put the Petal Files Over the Backside of the Calyx and Arrange Them So That the Lower Ones Fit Between the Upper Ones. Shape the Petals with a Hair Dryer or Lighter Towards the Calyx. You Can See the Method in My Water Lily Video: https://youtu.be/jGzSN1bL93I Be Careful Not to Melt the Calyx or Fuse the Petals With It, as They Should Spin Freely. Glue the Calyx (With Petals Attached) Into the Hole in the Brick. Prusa Lover Spinning Sun Print Each One of These Files Without Supports: - Brick_V02 - Disk_V02 - Stick_V02 - Sun_inner_V02 - Sun_outer_V02 The Brick is Printable in Two Colors by Swapping Filaments at Layer Height 14.2 (If Printed with 0.2 Layer Height). The Disk is Also Printable in Two Colors by Swapping Filaments at Layer Height 2.2 (If Printed with 0.2 Layer Height). Print the Stick and Glue It Into the Hole on the Backside of the Disk. Print Sun Inner and Put It Over the Stick. Print Sun Outer and Put It Over the Stick. Glue the Stick (With Sun Parts Attached) Into the Hole in the Brick. That's It! Have Fun With These Amazing Bricks!