Frenzy Brick "Prusa Lover"

cults3d

This Brick is for All Prusa Enthusiasts... ...but Especially for Tom Jackson (@FilamentFrenzy on Twitter) and His Wall of Bricks. You Can Choose Between Two Versions of This Brick: Prusa Lover with Daffodil (V01) Prusa Lover with Spinning Sun (V02) Instructions: Prusa Lover Daffodil Print Each One of These Files (No Supports Needed): Brick_V01 Calyx_V01 Petal_01_V01 Petal_02_V01 The Brick is Printable in Two Colors by Performing a Filament Swap at Layer Height 14.2 (If Printed with 0.2 Layer Height). If You Don't Know How to Set Filament Swaps in Your Slicer, Feel Free to Watch My Tutorials About It: https://youtu.be/i9IEojl87tI https://youtu.be/RZgDdki_ZHk The Calyx is a Solid Body and Should Be Printed in Vase Mode. Alternatively, You Can Print It Without Infill and Without Top Layers. Print Both Petal Files. Put the Petal Files Over the Backside of the Calyx and Arrange Them in a Way That the Lower Ones Lay Between the Upper Ones. Shape the Petals a Little Bit with a Hair Dryer or a Lighter Towards the Calyx. (You Can See the Method in My Water Lily Video: https://youtu.be/jGzSN1bL93I ) Be Careful That You Don't Melt the Calyx or Fuse the Petals with the Calyx, as They Should Be Able to Spin Freely. Glue the Calyx (With the Petals Attached, but Don't Put Glue on the Petals!) into the Hole in the Brick. Prusa Lover Spinning Sun Print Each One of These Files (No Supports Needed): Brick_V02 Disk_V02 Stick_V02 Sun_inner_V02 Sun_outer_V02 The Brick is Printable in Two Colors by Performing a Filament Swap at Layer Height 14.2 (If Printed with 0.2 Layer Height). The Disk is Also Printable in Two Colors by Performing a Filament Swap at Layer Height 2.2 (If Printed with 0.2 Layer Height). Print the Stick and Glue It into the Hole on the Backside of the Disk. Print Sun Inner and Put It Over the Stick. Print Sun Outer and Put It Over the Stick. Glue the Stick (With the Sun Parts Attached, but Don't Put Glue on Them!) into the Hole in the Brick.