Freewing 80mm LED Afterburner Adapter

thingiverse

This is a simple installation tool that lets you put a specific LED bulb into the tail cone at the end of most Freewing 80mm EDF outrunner units. It's made to fit the Yorkim Super Bright 3157 LED bulb on Amazon (check out the link below). After printing, push the adapter into the tail cone hole on the EDF unit. It should fit in there very snugly. If you're having a hard time getting it to fit, try scaling down the size by about 1% and see if that helps. I recommend using some glue to keep it in place. Once you get the adapter into the tail cone of the EDF unit, you can put in the LED bulb. For the LED, cut off the yellow plug cap and solder the wires as needed. With the cap removed, the round circuit board of the LED bulb should fit tightly into the top of the adapters. I recommend using glue to make sure it stays in place. For more detailed instructions on how to install your own afterburner, check out this website: https://www.rcgroups.com/forums/showthread.php?3313547-Make-your-own-EDF-afterburner For the LED bulbs used with this adapter, see here: https://www.amazon.com/gp/product/B07R3Z1K3B/ref=ppx_yo_dt_b_asin_title_o03_s01?ie=UTF8&psc=1