Freelancer Nomad Battleship Printable sections

thingiverse

I built in Glow-in-the-Dark PLA to give it that otherworldly feel by splitting this design to fit a printer with a 120x120x120mm print area. Section three gave me some problems, so check your support settings when making it or you'll end up with spaghetti. If you have editing software, I suggest breaking it into two halves again so it can print with minimal need for support. Part four is all three fins as one group but there are individual fins (they're different because of how I cut them from the original model - I've got limited editing tools and skills). If you need to print each fin individually, they're available. This time, I included a master file with all the parts split. Cura settings include: Layer height 0.1mm, shell thickness 0.8mm, retraction enabled (min ravel 1.5, min extrusion: 0.02mm, z-hop: 0mm), bottom/top thickness 0.6mm, fill density 10%, print speed 50mm/s, print temp 215C (depending on printer and plastic), bed temp 55C (depending on printer and plastic), support everywhere, raft, diameter 1.75mm, flow % 100%. Check out the Freelancer Group on Thingiverse - post requests, advice, prints, game memories, anything really: http://www.thingiverse.com/groups/freelancer-video-game