Free standing screwdriver stand

prusaprinters

Should fit most common screwdrivers and drills. The weight of the handle doesn't matter as long as the center of mass is 150mm or lower. The stand isn't balanced by the screwdrivers in it, and will stay upright even with just one screwdriver in it.If you want to be sure that your tools fit, you can use the parameters below to check. There are some trays to put random stuff (slightly deeper in the model than the print shown in the photo).Shaft no wider than 4.8mm in diameter. (4.5 is ideal)Center of mass no higher than 150mm when measured from the tipA handle of 35mm diameter must start at least 125mm up when measured from the tipA handle of 25mm diameter must start at least 90mm up when measured from the tip