Frankensteiner 5015 Hood Split

thingiverse

This is a split version of the Frankensteiner hood for a 5010 and 5015 fan. I love the original design but if the duct gets damaged you really need to reprint the entire thing. It was also hard to print so I split it to 3 pieces. The BL Touch which hopefully will not have to be removed or messed with once it is mounted. I also put a hole in it above the set screw so that you can adjust the BL Touch if it acts up without removing anything, mine does from time to time. The shroud I split the duct off of since once it is printed it pretty much doesn't need to be replaced. The duct I made the ability to bolt on using the M3 screws off of the original stock fan inside shroud since that's what I had handy. Overall it is a tight fit but It could have been that the duct was done in resin. I did have to dremel a bit , you might not have to. I'm sure someone with better CAD ability could do a better job but it works for me and hopefully it works for someone else too. Kudos to Calvin_MegaZero for the original fantastic design that I just tweaked for my needs.