Francesca Halloween Magic Wand

thingiverse

This is the Halloween magic wand I created for my daughter Francesca; starting from Patrick Mahoney's project, I wanted to make it happen too but I encountered several problems so I finally re engineered everything. The handle is made in 2 parts, cut asymmetrically for convenience, contains useful space for 2 AAA batteries a scar for the wire of the negative pole and a hole for the same as well as a hole for the positive pole in the central area. I attached STL both integer and sectioned as interesting to me. As in Patrick's project I use an LED (in my case 3mm white 3v) and an inertial switch that is OFF when horizontal. Minimum cost. The thin part is a single piece and long with an embroidery similar to the handle, the lower part penetrates into the handle and is also a container for the vertical sensor. The pieces were printed in ASA all without supports, the handle horizontally in two parts while the thin vertical part with a lot of brim to support it being very tall but thin.