Frame Motor for Kossel / Deltaprinter 20x20

prusaprinters

<p>This is sort of a remix from the Kossel "frame_motor_2020sw".<br/> Which means i created the thing completely new in fusion360.</p> <p>I could not found the source because there are so many of these parts on thingiverse.</p> <p>Changes i made:</p> <ul> <li>changed the distance for the motor, to ad a vibration damper which i found here<br/> <a href="https://de.aliexpress.com/item/Hot-sale-5-pcs-lot-Nema-17-stepper-motor-Vibration-Damper-shock-absorber-for-42-step/32764435765.html">https://de.aliexpress.com/item/Hot-sale-5-pcs-lot-Nema-17-stepper-motor-Vibration-Damper-shock-absorber-for-42-step/32764435765.html</a></li> <li>made the cutout for t-nuts bigger</li> <li>made holes through the whole part for tighten the screws for the motor</li> <li>made a small cutout on the underside for cables (endstops)</li> <li>smaller radius next to the screws, which holds the motor for adding washers</li> <li><p>just 3 instead of 4 from this long sections parallel to the extrusion<br/> Version 1: Tested. A little bit hard to insert the extrusion, and not to much space for cables on the underside.</p> <p>Version 2: Tested. Bigger cutout on the underside (radius 5mm instead of 2.5mm), smaller radius in the corners, where the extrusion goes through (0.5mm instead of 1mm)</p> <p>Version 3: Tested. Small update. Rounded the corner/area where the cable bends from the underside to the extrusion. Had some troubles to move the cable, when the extrusion was in place. And changed the logo slightly :-)</p> <p>Any feedback is welcome</p> </li> </ul> <h3>Print instructions</h3><h3>Category: 3D Printer Parts Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> <a href="http://amzn.to/2rqZ6Uo">Prusa Mk2</a></p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> Doesn't Matter</p> <p><strong>Resolution:</strong> 0.25</p> <p><strong>Infill:</strong> 20%</p>