Frame for Inky Frame 5.7"

thingiverse

This is a picture frame/case for the [Pimoroni Inky Frame 5.7"](https://shop.pimoroni.com/products/inky-frame-5-7). The frame features a slide-out, locking back plate and has space for a 4x6 (10x15 cm) piece of protective glass (1.6mm thick - I used [this one](https://www.amazon.com/dp/B08R8Q5PBF)). The Inky Frame PCB fits into a groove in the frame. The fit is pretty tight, so friction holds it in well, but you'll probably also want to use some adhesive or a bit of foam behind the PCB to hold it in place. There's plenty of room inside for a small LiPo battery (~7.5mm from the back of the PCB to the back plate). Small holes can be drilled in the back plate as needed for attaching legs or hanging hardware. Note: as this is intended for use in a non-interactive project, there is no access to the Inky Frame's buttons from outside the frame.