Fractal R5 PSU Shroud

prusaprinters

FeaturesA decorative power supply shroud for the Fractal Design R5, but will likely fit several mid-tower-sized cases with removable hard drive trays 410mm long, 94mm tall, 170mm wide Includes a 120/140mm fan mount for GPU cooling, cutouts for cable routing, and a sloped design for better front airflowPrinting GuidelinesLayer height: 0.2/0.3mmSupports: NoBrim: Yes (front, mid, rear), No (fangrille)Walls: 2+Infill: 10%+I suggest printing everything in the orientation the model comes in, to prevent excessive overhangs or build plate artifacts from being visible.AssemblyRemove all brims and glue the rear, mid, and front together - the rear and mid slide together neatly, then the front presses on afterwards. Once set, glue the fan grille on. This may be a tight fit, so you might need to sand the edges down slightly. Install a fan (if you want), remove the Fractal's bottom HDD cage (you can keep the top one) then slip the whole assembly into your case - the very rear of the shroud should slip between the PSU and the PCI-E slots. Cable route as needed, and you're done.