FR# Print Files

thingiverse

***NOT FOR COMMERCIAL USE*** Prints are available for the FRH, FR7, FR8, FR10, and Slammed FRs. DJI HD Notes: Most builds require a longer camera cable, such as the DJI Mavic Pro PTZ Camera cable. Arm Guard: Frame Specific Immortal T Horns: Universal, expected to work with Session and Hero 7 mounts HD Camera Holders: - Session ND: Designates Session 5 with TBS or Pyro ND filter - Hero 7: Designates Hero 7 - Hero 8: Designates Hero 8 - Logo: Designates logo on holder FPV Camera Uprights: - Session: Designates Session 5 specific Uprights - Universal: Designates Session 5 and Hero 7 Specific Uprights - Full Size: Designates Full Size camera or Mini camera with adapter - Micro: Designates Micro (19mm wide) camera. The original Session Micro upright is compatible with both Session 5 and Hero 7 camera holders, for most camera angles. A Universal Micro Upright has been added, which raises the camera by 3mm, allowing for lower FPV camera angles. - Slug: Designates addition of stiffening slug - Hero 8 has dedicated uprights Platypuss Tails: Assembly will not accept the TBS bulkhead style coax connector. MMCX coax needs to be a 90 deg MMCX connector, 10cm length seems to work well. Works with 18x18 Micro Ublox GPS. - Diversity: Designates Crossfire Diversity shelf - Mach3: Designates Mach3 shelf - Unify HV UFL: Designates Unify HV (800 mW ufl connector) shelf - Unify HV MMCX: Designates Unify HV SE (1000 mW mmcx connector) shelf - Double SMA: Accepts double SMA coax connectors - StraightSMA: SMA hole comes out straight from the tail - AngledSMA: SMA hole comes out angled from the tail - RXHoles: Accepts standard 3mm OD antenna tubes - 180GPS: Designates BN-180 GPS - MatekGPS: Designates Matek SAM-M8Q GPS Prints are available for the FR# SLAMMED, which does not fit FR10. Slammed version uses 18mm front standoffs and 10mm rear standoffs. Designed for the FR7, to provide a flat surface for bottom mount batteries and a place to add small components, like a rx module. Trunk Info: TPU Files The following require 6mm long, 5mm OD standoffs. - Trunk Empty_Standoffs* - Trunk Hex Fillers_Standoffs (hex shapes for added stiffness) Rigid Material Files No standoffs required - Trunk_Rigid Material_without Standoffs