FPVWRA Spec Wing Motor Mount

thingiverse

Motor Mount designed for Wind Catcher RC wing but should fit most spec wings. Two-part design allows for easy installation and removal of the motor by simply unscrewing the bolt. I have released two versions of the MotorMount file: V1 has slightly tighter tolerances, so if you print it and it doesn't push on easily, you can either sand it down or try printing V2 for a slightly better fit. This can vary depending on your printer's specifications. Requires: * 1 x 25mm M3 socket head cap screw * 4 x 10/12 mm M3 socket head cap screws (depending on which mount you install, read below) * 1 x M3 nut UPDATE: I received reports that the originally recommended M3x12mm bolts were too close to the windings, especially near where the wires enter the motor. I now recommend using M3x10mm instead. This provides a slightly shorter thread and reduces the risk of shorting the motor. UPDATE: To address this issue, I created two versions of the motor mount - 10MM and 12 MM. The labeling clearly indicates which screws to use for each version. As always, double-check how far the screws go in and use your best judgment. Both versions also feature a slightly larger dome on the bottom where the motor shaft protrudes, providing more clearance compared to the original design. Happy flying!