FPVCycle Prototype 5 TPU Shoes

thingiverse

(NOTE: This shoe is designed to be a very snug fit! Due to slight inconsistencies between batches of carbon, these shoes may seem too small for some users. In these scenarios, I've had good results after scaling the model up a few percentages!) A shoe for your FPVCycle Prototype 5! (arm skid/guard/protector) These shoes will protect your arms and hardware from damage, as well as well give you ~6 mm of ground clearance! The 7 mm hole in the bottom will allow you to access the motor's shaft screw for removal of the bell without removal of the entire motor! Kabab says not to use TPU shoes on the arms, but Kabab has incentive to sell you more arms now doesn't he??? The choice is yours, I'm only here to provide you with options. ;) My prints come out at 4 grams each with 100% infill and 2.7 grams each with 50% infill. Print upside down with support.