FPV49 V4 Delta wing FPV, main box, cover

thingiverse

<h1>This is the main thing for project of FPV49 Trond in my version</h1> <b>I planned</b> - a canopy (aka box), with cover (air scoop for ESC cooling) content of this thing - nose plus skid https://www.thingiverse.com/thing:4681270 - two small air scoops for VTX and RC RX https://www.thingiverse.com/thing:4682112 - foldable spinner https://www.thingiverse.com/thing:4681378 As a main thing I marked blue on the pictures what is planned and 3d printed In this thing there're the <b>front box, aft box </b> and <b>front cover, aft cover</b>. I glued front-aft together with epoxy. I used a leftover carbon rod for the cover front as hinge pin. <b>The basic setup:</b> 6mm depron cut, followed FPV49 V4plans It accommodates a APM mini with GPS, FPV gear with OSD and telemetry to ground station. It is a quiet old system, but still working fine. I modified the wingtip, to be upward only, instead of symmetrical, made from depron with carbon plate inside. I think it should do the job as commercial aircrafts has winglets, too which point only upward. Motor: EMAX GT 2815/06 Servos: Corona DS339MG Battery: 3S 5200MAh Flight control: Mini APM w. GPS VTX: Boscam 5.8G 32CH As for future Air data module will be installed for air speed. <i>Note: This is not a final product is under development, full list of details will follow</i>