FPV Monitor

FPV Monitor

thingiverse

The Case Is Printed Lying On Its Front. Hardware Installation: - First, Push In the USB-Charger Board. - Then Carefully Insert the Display With A Bit Of Force. - Next, Install the Control Panel (The Plate With Three Buttons) And Secure It With Screws. - After That, Attach The Control Plate Behind The Display And Connect The Flat Cable. - Then Push In The Antenna Port And Secure It From The Outside. - Next, Remove The Long Plates From The Switch And Connect The Cables. - Now Just Connect The Batteries (Two 18650s) With Cables And Insert Them Into Their Folders. - You Can Use Clips To Secure The Display With Two Screws. This Case Is Designed For: Monitor Kit: https://www.banggood.com/RX5808-5_8Ghz-48CH-FPV-Receiver-with-480320-5-Inch-HD-Display-Snow-Screen-Monitor-DIY-For-FPV-Goggles-p-1309235.html?rmmds=myorder&cur_warehouse=CN USB-Charger: https://www.banggood.com/TP4056-Micro-USB-5V-1A-Lithium-Battery-Charging-Module-Board-TE585-Lipo-Charger-p-1225993.html?rmmds=myorder&cur_warehouse=CN Switch: https://www.banggood.com/5pcs-Black-Push-Button-Mini-Switch-6A-10A-110V-250V-KCD1-101-2Pin-Snap-in-OnOff-Rocker-Switch-p-1096122.html?rmmds=myorder&cur_warehouse=CN You May Also Order An Adapter With The Same Antenna Connector: https://www.banggood.com/SMA-Female-To-Female-Adapter-Connector-RPSMA-p-920352.html?rmmds=myorder&cur_warehouse=CN M2 Or M2.5 Screws Are Used. Important: Connect The Two 18650 Batteries In Parallel. Have Fun Building It! Update: The Cover Has Been Slightly Modified To Make It Easier To Print, And The LED Cutout Has Been Revised. Update 2: The USB Port Has Been Modified As I Had Some Usb Cables That Didn't Fit.

Download Model from thingiverse

With this file you will be able to print FPV Monitor with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on FPV Monitor.