FPV Copter Stand 2" - 4"

FPV Copter Stand 2" - 4"

thingiverse

Check out the other Version for different sized quads! Find it at my designs: https://www.thingiverse.com/rookiefpv/designs MATERIAL: PLA. Do not use TPU or PETG. You will need to heat and bend the print afterwards (funny sh*t going on here!) HOW TO PRINT: Bottom: 100% infill to give some weight. TOP: 25% infill with at least 4 walls String: 25% infill with at least 4 walls. Print them standing. No supports at the screwholes!!! I recommend 0,2mm layer height for estethics. ASSEMBLING: Use (8x) 8mm M2 screws. You need the lenght for stability. Shorter screws are not recommended. IMPORTANT / HOW TO: !!!After printing, assemble the top-plate 120 degree off (relativly to the bottom-plate)!!! Make sure the strings sitting flush and neat in the corresponding holes at the top- and bottom-plate. Then heat the 4 strings evenly with a hairdryer until they get soft enough to twist. I recommend to handle the print with both hands, while the hairdryer rests on the table f.e. then: twist them 120 degree to the right position, then tilt the top-plate in your desired position. I recommend about 30 degree for a secure stand. No need to rush. Take your time, make the strings hot enough, they take a lot of heat before they start actually "melting away". Took me good 3-4 Minutes to heat them up enough. Then twist carefully, you got time! The Print will stay flexible for at least a minute. If needed, just re-heat the thing and do your corrections. Have fun and post a picture :)

Download Model from thingiverse

With this file you will be able to print FPV Copter Stand 2" - 4" with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on FPV Copter Stand 2" - 4".