Four hard drive stand with tabs

thingiverse

Minimalist Hard Drive Stand Made Easy The minimalist hard drive stand consists of four thin strips with screw holes and slots for four 3.5-inch hard drives. "Mounting tabs" serve primarily as spacers, but they also enable the stacking of drives in a case where expansion cards would normally be placed, alongside an ITX motherboard that doesn't extend into this space. This design is not intended for hanging off mounting tabs or holding drives vertically, so use it at your own risk. It was printed using standard PLA and proved to be quite rigid, but ABS could provide even better results. The model can be easily modified if needed by cutting down the existing parts, allowing for customized uses. Printing four stands is sufficient, as they can be attached either right-side up or upside down.