Fossil Carlyle Watch Stand

prusaprinters

A watch stand charger holder for a Fossil Gen 5 Carlyle, I'm not sure if it works with other smart watches, it uses a 26mm diameter and, 8mm thick charging puck. Wire from the charger is routed through the back and down the spine of the stand. Placing the cable into the channel takes a bit of force, I used the edge of a card to slot it in; it shouldn't do any damage. After the cable will route out of the channel in the spine of the stand. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: Yes Resolution: 200 Infill: 20 Filament: PolyMaker PLA Notes: Print on the back side with the cable channel. Depending on how well you can do overhangs supports may be necessary in the recess for the charger. Category: Accessories