Foscam R2 30 degree mount

prusaprinters

<p>This is a mount to allow a foscam R2 to be mounted at a 30 degree angle. The reason for this was to look over an edge, though it will make the pan tilt seem a bit weird since it is no longer horizontal. The mount is designed to use a 1/4-20 bolt that is 3/4" long to mount the camera, you may need a washer in case the stick out on the bolt is too long for the camera.. There are 3 versions, which are all the same basic design, but two of them have ears which may help with mounting either with double sided tape or screws. The holes on the "C" version are 6mm for no real reason other than that's what I thought looked about right. This is untested and so will be a work in progress, maybe forever.</p> <p>Update: This was tested and worked, but I am still leaving it as a work in progress.</p> Category: Camera