FormD T1 PSU Supports

thingiverse

These brackets help better support the PSU in the FormD T1 SW across a few configurations. There are definitely more combinations of T1 slots and PSU stand-off lengths not included here, so the NX *.prt files are provided if you want to customize the designs further. A couple notes to start with: * I designed these supports to fit with the T1 SW v2, though they might work with other T1 versions (I haven't tested them). * This design is only compatible with the "default orientation" of the PSU (see picture). * The stock T1 PSU mounting bracket must be installed in the T1 Top Strut (i.e., "spine") holes closest to T1 Front Panel using stand-offs as described below (see picture). * For all configurations a single countersunk M3x8 mm screw is used to secure the PSU Support (this design) to the stock T1 PSU mounting bracket. Additional screw requirements are outlined below. ##### *5 mm PSU Stand-Offs* ##### 2.25 slot configuration You will need TWO countersunk M3x6 mm screws (or longer). ##### 2.50 slot configuration: You will need ONE countersunk M3x6 mm screw (or longer). ##### 2.75 slot configuration You will need ONE countersunk M3x6 mm screw (or longer). ##### *10 mm PSU Stand-Offs* ##### 2.25 slot configuration You will need TWO countersunk M3x6 mm screws (or longer).