Ford Windstar 1993-2003 AC Knob

thingiverse

I have a ford mk6 transit minibus which had a windstar AC unit for the back of the bus. Both of the knobs had split and required replacement. A new unit was only £25 but suffered from £50 shipping from the US, so I quickly modelled up these like replacements. I haven't printed these yet, but they should fit OK. To make them illuminate perhaps put a filament sized hole through the model at the point of the arrow. The original knobs also had a stop point. I only have one knob so couldn't easily see where it was for the 2nd. It's easy enough to add one on tinkercad. I'll be printing in PLA but I recommend ABS for something inside a car, probably grey is a good colour since that's the original one and use 10-20% infill. It will require supports.