Ford Transit Ceiling Wiring Loom Harness

prusaprinters

<p>This clip snaps into the holes in the frame of the Ford Transit ceiling to replace broken or missing factory clips. There is a slot to hold a 4mm-wide zip tie to secure the wiring loom. (Note: ziptie slot not yet tested.)</p> <p>The snap fit is reasonably tight and difficult to push in (to avoid inadvertently falling out while moving.) If it's not snapping in properly (a proper snap should produce a loud clicking sound), then try to reach inside and pull the compliant snap mechanism up a little bit, or sand off the very tip of the catch.</p> <h3>Print instructions</h3><p>Prints in the orientation provided in the file. No supports are required.</p>